Battery powered operation with minimal current drain

•             Built in LCD display with "Push to Read" button
•             Low system cost
•             Multiple sensors on a simple three wire cable
•             200 counts per revolution for the SDI-12 output

Applications

•             Scales  the encoder position into user units of Feet, Meters, etc.
•             Precision dual bearing design with special low temperature lubricant
•             Threaded shaft compatible with older mechanical shaft encoders
•             Zero backlash
•             Sealed enclosure protects from moisture and dirt
•             Low current operation (less than 800 microamps typical standby)
•             High speed encoder circuitry prevents missing counts due to rapid movement from wave action or sudden movement in freeze/thaw conditions - 15 ft/sec typical

 

 

 

Data Input
General	Inputs	Shaft Position
	Outputs	SDI-12 & 2-Wire Quadrature
	Display	4 1/2 in Digit x .4 in characters with "LO-BAT" indicator
	Resolution (SDI)	200 counts/rev
	Resolution (Quadrature)	100 counts/rev
	Max Shaft Rotation	15 rev/sec
	Offset Adjust	SDI-12 or screwdriver
Data Output
SDI-12 Output	Baud Rate	1200
	Protocol	SDI-12  7-bit even parity, 1 stop bit
	Output Voltage Level:	Minimum high level: 3.5 volts
		Maximum low level: 0.8 volts
		Maximum cable length: 250 ft.
Quadrature Output	Type	Open Drain (optional factory installed pull up resistor to 5.0 V)
	Transient Protection	5.0 V Transguard
Power Requirements
	Voltage Input	9.6 to 16.0 Volts DC
	Current	Less than 2.0mA
		800μA typical
Mechanical
Physical	Bearing	Double bearing with external seal
	Starting Torque	0.15 oz in typical
		0.50 oz in max over temperature
	Shaft	5/16 in. compatible with Stevens and Fisher and  Porter pulley and accessories
	Shaft Length	2 in
	Shaft Clearance	1.75 in
	Shaft Thread	24 threads per in
	Thread Length	0.75 in
	Material	Anodized Aluminum
	Size	5.125 in wide (main unit)
		7.0 in wide (base plate)
		4.25 in high
		4.0 in deep (not including shaft or connectors)
Connector	H-3311	Amphenol MS3102R14S-6P (6-Pin male)
	Cable	Amphenol MS3106A14S-6S (6-Pin female)
	(One 6 foot cable provided with the H-3311
Environmental
	Operating Temperature	-40° C to 60° C
	Storage Temperature	-50° C to 70° C
	Humidity	0 to 100%
Miscellaneous
Warranty	The WaterLOG® H-3311 is warranted against defects in materials and workmanship for two years from date of shipment.
Specifications subject to change without prior notice due to ongoing commitment to product testing and improvement. LR Jan 10 2008

 

Manuals

H-3301/3311 Manual

Catalogs & Brochures

H-3301/H-3311/H-3342 Shaft Encoder Brochure

 

		H-3301-CABLE Communication Cable H-3301-CABLE Communication Cable for H-3301 & H-3311 Shaft Encoders