
H-3551 The "SMART-GAS" System
The WaterLOG® Model H-3551 "SMART-GAS" is a constant flow bubbler. Replace the dangerous high-pressure gas bottles, oil sight feeds, flow regulators, and leaky manifolds found in gas purge pressure measurement systems with this unit. It is reliable, light weight and uses low power operation powered by 12-volt battery and solar panel.
DAA has Authorized Distributors all over the globe. View a map and find your closest contact for DAA H-3551 The "SMART-GAS" System products and accessories.
Have a question about your H-3551 The "SMART-GAS" System? Check out the support page with resources compiled just for you.
Want to return a product for service? Here you'll find authorized service centers and instructions on how to send in your H-3551 The "SMART-GAS" System.
APPLICATIONS
Use for stream, lakes, well monitoring, tide, ocean, reservoirs, and waste water.
KEY FEATURES
|
|
| INTERFACE | |||
|
RS-485 Electrical Specifications
|
Protocol | Flexible | |
|
Commands |
Half-duplex, 8-bit, no parity, 1stop bit |
||
| Baud Rate |
9600 |
||
| |
|||
| ENVIRONMENT | |||
| Temperature | Standard Operating Range | -40° to 60° C | |
|
Storage |
-50° to 80° C |
||
|
It is recommended to install unit in weather shielded enclosure |
|||
| Gas Delivery | Particulars | Microprocessor controlled unit | |
|
Gas Flow Technology |
Constant mass flow |
||
|
Gas Flow Control |
Bubble rate is user programmable from 30 to 120 bubbles per minute based on 1/4 in. tubing orifice pointing down. Auto zero error controlled flow nozzle (patent application in process) (NO NEEDLE VALVE PROBLEMS) | ||
| Compressor | Type | Piston compressor (NO BROKEN DIAPHRAGM PROBLEMS) | |
|
Operation |
Low duty cycle (7 hours typical run-time per year at 60 bubbles per minute flow rate into 12 ft. of stage-purges not included) |
||
| Purge Functions | Purge Pressure Level | User Selectable 15 psi to 80 psi | |
|
Options |
• Manual • SDI Driven purge • Remote controlled |
||
| |
|||
| MECHANICAL | |||
|
Physical |
Enclosure | Sealed corrosion resistant fiberglass | |
|
Size |
10” wide x 12” long x 6” high 25.4 cm wide x 30.48 cm long x 15.24 cm high |
||
| Weight |
12 lbs. (5.44 kg) |
||
| Mounting | Hardware supplied for wall mounting | ||
|
Pressure Outlet |
1/8 in. FNPT |
||
| Sensor Pressure Outlet |
1/8 in. FNPT |
||
| Reserve Tank Outlet |
1/8 in. FNPT (80 psi MAX) Pressure relief valve included |
||
| |
|||
| MISCELLANEOUS | |||
| Warranty | The WaterLOG® H-3551 is warranted against defects in materials and workmanship for two years from date of shipment. | ||
| Specifications subject to change without prior notice due to on going commitment to product testing and improvement. LR January 15, 2011. D02 031 | |||
|
|
H-253 Orifice KitH-253 Orifice Kit |
|
|
|
H-355-Cable RS-485 Communication Cable to DAA LoggerH-355-Cable RS-485 Communication Cable to DAA Logger |
|
|
|
H-355-DES-1 Desiccating Air Dryer (600 Cubic Feet)H-355-DES-1 Desiccating Air Dryer (600 Cubic Feet) |
|
|
|
H-355-DES-2 Desiccating Air Dryer (4400 Cubic Feet)H-355-DES-2 Desiccating Air Dryer (4400 Cubic Feet) |
|
|
|
H-355-DP Replacement DesiccantH-355-DP-1 Replacement Desiccant for H-355-DES-1 Air Dryer |
|
|
|
H-355-DP-1 Replacement DesiccantH-355-DP-1 Replacement Desiccant for H-355-DES-1 Air Dryer |
|
|
|
H-355-DP-2 Replacement DesiccantH-355-DP-2 Replacement Desiccant for H-355-DES-2 Air Dryer |
|
|
|
H-355-INS Installation KitH-355-INS Installation Kit (includes 2 - 1/8" NPT to 1/8" tube fittings, 1 - 1/8" NPT to 3/8" tube fitting, and 6 ft. 1/8" copper tubing) |
|
|
|
H-355-OL Orifice LineH-355-OL Orifice Line (1000 ft. minimum) |
|
|
|
H-3551SDICABLE Bubbler SDI-12 Communication CableH-3551SDICABLE Bubbler SDI-12 Communication Cable |
|