• Menu driven user interface
• Self-timed and random transmissions
• Configuration Query allows examination of set-up parameters
• Built-in key pad and easy-to-read display can be used for complete system configuration or to view measured values.
• Binary or ASCII data format
• Selectable data order
• Ability to transmit different data than what is logged to the internal memory
• Extensive built-in software
• Configuration and Control implemented by external device via RS-232 interface
• User programmable data rates of 100BPS, 300BPS or 1200BPS
• Time of day query retrieves GPS time
• Complex function software for special applications
• Two RS-232 Serial Ports for use with local terminals, modems, GOES Radios, remote displays, etc.
• Four analog inputs
• SDI-12 Master mode
• Two programmable digital inputs/outputs
• One event counter input (Tipping Bucket Rain Gauge)
• Frequency input (wind speed)
• Quadrature shaft encoder input
• Scalable and programmable 4-20 mA output
• Data logging capability using nonvolatile internal storage (16 MB and up)
• Low standby power
• Sealed, corrosion-resistant, nonconductive enclosure
• Operating temperature range of -40° to 60°C
• Simple RS-232 connection for downloading data, and programming with a laptop and/or PDA unit with no special software required
• XL Basic programming capabilities
• PCMCIA Flash Card port for easy data collection and Firmware updating

 

 

Performance
General Analog Input	Channels	4 (Single Ended)
	Ranges	Programmable (Channel1 Only)
	Resolution	16-bit Resolution (1 Part in 65536)
	Accuracy	±0.02%
	Input Ranges	0 to 5 V (All Channels) 0 to 500 mV (Additional input range only available on channel1)
	Excitation	5.0V switched, ratiometric with A/D, 10mA max load
	Accuracy	± 1.0 mV Over load and temperature range
Frequency Input	Input Range	1-10 KHz at ±75 mV or greater 1-15 KHz at ±1 V or greater
	Input Amplitude	± 5.0 Max
	Accuracy	± 0.1%
	Resolution	1/10000 * Reading
Counter Input	Type	Switch closure or voltage pulse, Internal 50k pull up resistor, falling edge triggered.
	Input Voltage	0-5 Volts
	Minimum Pulse Width	5 mS
	Input Frequency	100Hz (max)
Digital I/O	Channels	2; Independently configured for input or output
	Input Voltage	0-5 V
	High Level	3.5 V (min)
	Low Level	0.8 V (max)
Output Voltage	Low	0.4 V (max)@ -5mA
	High	3.5 V (min)@+5mA
4-20 mA Output	Resolution	4.0 µA
Data Storage	Type	Non-volatile Flash
	Size	16 MB minimum; expandable
Interface
SDI-12 Master Mode	Protocol	SDI-12, 7-bit even parity, 1 stop bit
	Baud Rate	1200
RS-232 Communication Ports	Protocol	RS-232, 8-bit, no parity, 1 stop bit
	Baud Rate	Programmable
Cables/Connectors	9-pin RS-232 cable 9-pin D Male to Male Gender Changer RS-232 Null Modem Adaptor Sensor Terminal Block
Certification	NOAA/NESDIS certified for self-timed and random GOES transmissions
Data Logging	Data is stored internally to non-volatile memory
Enclosure	Sealed, corrosion resistant fiberglass with clear Lexan® window
Environmental	Operating  Temperature	-40° to 60°C
	Storage Temperature	-40° to 80°C
	Humidity	0-95% non-condensing
GOES Transmitter	Type	100, 300, or 1200 BPS with built-in GPS receiver
	Frequency Coverage	100 and 300 BPS: GOES Domestic Channels (1-199) 100 BPS: International Channels (202-266) 1200 BPS: HDR Domestic Channels (1-100)
	Frequency Stability	Over Temperature: ± 0.4 PPM Long Term: ± 1 PPM (including temperature) Frequency Setting: To an accuracy of 1 Hz under software control
	Output Power	100 / 300: 6 Watts (nominal) Linear 1200: 9 Watts (nominal) Linear Output: 50 Ohms, short and open circuit protected
Mounting	Hardware supplied for wall mounting
Power	Input Voltage	10.0 to 15.0 Volts
	Input Current - Sleep Mode	< 16 mA typical
	Input Current - Active (measuring, display off)	60 mA average
	Transmit	< 3.0 A
Warranty	The WaterLOG® H-522+™ is warranted against defects in materials and workmanship for 2 years from date of shipment.
Specifications subject to change without prior notice due to ongoing commitment to product testing and improvement. LR October 2, 2009

 

Manuals

XL Series Manual (H350XL, H500XL, H522, H522+)

H-223 - User Manual

H-339 Manual

XL Basic Programing Guide

FAQs

Downloading with Hyperterminal

Using Functions for Remote Call out

Battery and Solar Panel Selection

RS-232 Communication

Remote Datalogging

GOES V2 Clarification

Menu Trees

XL Keypad Menu Tree

XL PC Menu Tree

Catalogs & Brochures

H-223 Brochure

XL Brochure

White Papers

Modbus Application Note

XL Remote Commands

Firmware

H-522+ - v4.30

H-522+ - vV4.41

H-522+ - v4.42

H-522+ Firmware - v4.44

 

		H-223 401.8 MHz GOES Antenna with Pole Mount H-223 401.8 MHz GOES Antenna with Pole Mount
		H-223-GPS GPS Dome Antenna H-223-GPS GPS Dome Antenna
		H-223-PM Pole Mount H-223-PM Pole Mount for H-223 GOES Antenna
		H-223-SM Side Mount H-223-SM Side Mount for H-223 GOES Antenna
		H-224 GOES Antenna Cable H-224 GOES Antenna Cable, Type N Male/N Male (20 ft.)
		H-224-CUSTOM Custom Antenna Cable H-224-CUSTOM Custom Antenna Cable
		H-224-GPS Custom GPS Antenna Cable H-224-GPS Custom GPS Antenna Cable
		H-224-GPS GPS Antenna Cable H-224-GPS GPS Antenna Cable, Type TNC Male/TNC Male (20 ft.)
		H-228 GOES Transmitter Lightning Protector H-228  GOES Transmitter Lightning Protector
		H-350-RSC-9 RS-232 Cable, 9-pin Female to 9-pin Male H-350-RSC-9 RS-232 Cable, 9-pin Female to 9-pin Male
		H-350-USB-CABLE, XL Series, USB Adaptor, USB Cable Type A, Male to 5 Pin Mini-B H-350-USB-CABLE, XL Series, USB Adaptor, USB Cable Type A, Male to 5 Pin Mini-B
		H-355-Cable RS-485 Communication Cable to DAA Logger H-355-Cable RS-485 Communication Cable to DAA Logger
		H-3551SDICABLE Bubbler SDI-12 Communication Cable H-3551SDICABLE  Bubbler SDI-12 Communication Cable